My CM 4.0 Will not see the mm760 in v3 of my G700.
The MGP will see it and I was able to successfully
update firmware on it,; however, I get board not
inserted in CM 4.0. I have tried 3 board 1 white
and 2 gray faceplates, all with the same results.
I added in board in config, but no joy.
Any suggestions?
Thanks for your comments.
The MGP will see it and I was able to successfully
update firmware on it,; however, I get board not
inserted in CM 4.0. I have tried 3 board 1 white
and 2 gray faceplates, all with the same results.
I added in board in config, but no joy.
Any suggestions?
Thanks for your comments.