Recent content by JTDubai

1. Go to terminals and sets > DN 500 Make LINE 061 appear and Ring 2. If you have an Auto attendant/CCR setup in the voice mail, Change Line 061 Answer to No.

CDB is LD 15 (LD 22 can be used to display PRT ATT or PRT NIT parameters. ( i don't have a live system and stopped working on CS1K in 2014 :) MCR will stop ringing once answered. you can put that call on hold and answer the next key if there is a second incoming call. Otherwise need to program...

1. M3904 Key 0 and Key 1 Change it to MCR DN 2. Change Key 2 and 3 to MCR DN if you need to answer more than 2 calls at the same time. 3. Change the Night DN to the DN of the 3904 set in the CDB

Not sure how you do the Right Fax ,but If you have DNs associated with it ,You can configure CLID entry different than a normal one but falls in teh same DID range. And then all right fax related DNs can be mapped with the same CLID JT

Do you have DN configured with 4567? JT

Thats going t be tough unless there is work around using CLID routing. The otherway is to store the number in the address book and and match the incoming caller ID to a SPECIFIC Contact name so that at least there can be different display name for the incoming calls from this number JT

Dont think there is anything elase which controls 11xx Phone display back light other that the back light setting in the phone itself. JT

The Power to ELAN switch may be the reason? or someone is powering a device which has an ELAN IP connflict? JT

I did the firmware upload and converted the 11xx from UNISTIM to SIP. I can register phone with the CM incoming/outgoing working fine. I have below 2 requirements ,can Any one help? 1. I need to remove Presence and DND button from the Soft keys of the 1140 ( I know some of the features are...

oh no. I guess that's applicable to DID numbers only.Not for the numbers dialled after the AA answered. JT

Try BCM monitor>Line monitor.Hopefully it should show the number passed from the trunks. JT

Using which feature you restricted user dailling ACOD? JT

It's a CC6. In the CC management the agent name shows perfect. But on generating the report for two agent IDs it shows the same name.If I delete the agent and recreate will I loose the statistics? looks like the supervisors messed it creating and changing the agent. JT

Please print the VAS JT

Ideally it should be required should be less than the actual.You may have to reduce the duration for each type of reports.OR else your partition for database is small. JT