Thanks curlycord, I used to have it connected to my CICS but for the life of me I couldn't find the manual for the connections. This was a GREAT help!! Thanks again
I have an older Algo 3004 door phone and can't find the installers manual. I can't remember the wiring connections for the connection to the line port on the analogue port of the CICS.
HELP! Just connected a MICS. It took quite a while to boot up. When it did, sets say "in maintenance". I can't do any thing. How do I get it out of mtnce??
Jon
The unit has been in use for a number of years. I searched through Mbox directory and only had 23 in total. A non-initialized m-box should have shown up. When I tried to add a new box it said none available.
???
Jon
I've got a SC 1000 on an SX200 with ground start lines. When the 1st call comes in everything works fine. But when the 2nd call comes in, there is no notification of it. For the caller it just keeps ringing until the first call is disconnected. Is there a setting for ringing on busy?
Jon
I have set up copper to fibre adaptor, through to adaptor back to copper, then into a switch, back out to fiber back to copper to switch and then branch to LAN from there.
Jon
It does ring on second call.
It is not set for DND on busy.
I have rebooted the system a few times.
I've never come across anything like this before????
Jon
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.