Recent content by jer123

I try to setup the h323 link between avaya ip office and trixbox. I modified the ooh323.conf file. Now I can call any extension in trixbox from avaya. But when I call trixbox extension from avaya the calls get disconnected on answer. any help

hello, I am new to asterisk freepbx. I manage to setup with sip extensions and they work. now I am try to link this with avaya ip office.I have tried most of the setting in this forum and website but no luck at all. Can someone help me. I am running the very lates freepbx model 2.9

Has anyone got the call transfer working nokia mobile for SIP calls?

Guys, I managed to link IPO with Call manager by setting up a inter-cluster trunk (non-gatekeeper controlled) in Call manager. Now I can rings the handset in both end but no audio from any site

Tom, Did you get it the ip link working between IPO and CCM3.3. I really want to see CCM set-up

Guys, I have tested the VOIP link between two IPO they they work fine.I think it is all in the call manager configuration which I am not familiar. Have any one got it working IPO and CCM via ip trunk.

amriddle, Yes I can ping from each site.

I just check the fix setting it has got the same settings as what you send. !!

Amriddle, One of the firewall has that setting "no fixup protocol h323 1720" do I need to remove it?

Tom, Yes it is trying to dial via the IP line which I can see from system satus and the system monitor.When I run a wireshark to capture the packets it show it only try to setup with CCM but ackowlodgement never received from CCM

Amriddle01, Yab all those network equipments are cisco and what h323 fixup I got to remove?

Guys, I still can't get CCM and IPO integrated via h323 trunk. I even tried both system at same subnet still no luck. When I try to make a call to cisco phone from IPO all its say "incompatable disc"

Hi tlpeter, I have got shortcode to route calls via IP line. And all the settings in the IPO is OK since I know more about IPO than the call manager. I think I may have to carry out more settings in call manager which I am not familiar.If the CCM use 7200VXR as gateway do I need to consider...

tlpeter, no I am not using any prefix for ip line

Tom Mills, Thanks for your quick response. But still I can't make it work.When I try to test a call from IPO in doesn't go via IP line and the and I am getting incompatibale message in IP phones