Recent content by jed5962

I would look in the installation and Maint. callpilot 4.0 NTPs, also there is a Help menu next to the tools, when u logon to the call manager. The help menu has the ntps there, just look for the server install and maint. guide

cdrom has to be connected as well as the image cd 1 in the when u boot your 201 the will put a point were it will ask u to enter y to boot to dos, enter y ( you have 5 secs.). then it will take you to an option screen, tne take the scsi opt., which i believe is opt.1, then just, take the...

which type I201,703 tower, or 1002 rack ? each are slightly different.on how to image, but your software should have come with image cds.

remove it from the routes, idc no.then go to ld 49 then:chg,idc,dcno#,put in the inbound digit u want to remove when it comes up the that digit type in x, then return for the next one u want to remve.

just remember you are only as good,as your last backup.if callpilot fails, are you ok with a week old messages?. AppBuilder and Prompt achieve backup, only when you make changes. other than that maybe once a month

I installed the new Telephony Manager 3.0 , when accessing the web portion to admin phones, getting error ( T.M. does not see dongle ), this only occurs in the web, not in the classic

try using ops line cards it will provide supervision, the also make look into clid analog card

It would be the same setup as the Opt.11C, attaching the lantronix to one of the 3 ports. then setting the lantronix with an IP address as well as setting the baud-rate, an possibly a password if you are lucky