Options connecting O11c -> CICS/MICS

[MetlePro]

What options do i have except E&M trunks on the 011c.

Is it possible to configure analog trunks on the 011c to a analog set on the MICS/CICS?

 

[hawks]

T1, PRI, you can do the Analog like you talked about but it will not provide any Disconnect signaling when call is completed.

 

[MetlePro]

I'm trying it analog. But without succes.
I'm configuring the anal set on the 011c, en connecting it to a trunk on the CICS. Als tried connecting it trunk to trunk. without succes. I keep getting a dead line.

These systems are right next to eachother. so there's 1 physical analog line connecting the 2.

Any advice on programming trunks differently?
I've just been using standard Cot programming.

Pro reffers to my company, not my status

 

[hawks]

that should work, what pr are you punching down?

 

[worldwidedialtone]

Feed analog dial-tone from your 11 to the NORSTAR to a trunk port. Assign that Truk/Line to a 7310 or larger set as Ring and Appear. Your trunks/lines incoming to the NORSTAR skip a bit, so be sure of where it is connecting. Been a spell but I think 1 pair/Line pr2 2nd/line then it skips 2 pair so third line in te 5th pair on your block

MIKE

 

[jed5962]

try using ops line cards it will provide supervision, the also make look into clid analog card