Recent content by JacobNunley

by default it should do that. as long as the call started with Extension A.

I had a similar queston on a test i took. and I'm not sure if I got it correct or not.

If at site 1 you have G.711 to site 2 and from site 2 to site 1 you have G.729 what codec would be used?

In what order should you take the ccvp? Here is what I am looking at. I would like to start with Cvoice however; the books are not released yet. So I am not sure if I should start on CIPT or GWGK? CIPT CVOICE GWGK TUC QOS

Any thoughts on this?

If we start to move some exchange users over to 07 will their voice mail still work? I know that Cisco says that 07 is only supported by unity 5.0 but if we leave the 03 online would this help?

Call Manager 4.1

For some reason today our attendant console shows every DN in a unknown state. I have restarted the TCD service but that did not fix the problem. any ideas? Thanks Jacob

Has anyone setup a cisco system with shoretel? meaning being able to xfer calls between the two systems? If you have any horror stories please share them... Jacob

Brianinms You are 100% correct. and I think your right about just setting up two different Dns on the phone. \

Maybe this will make it clear what I'm trying to do. When using a FXO card, when a caller calls you see "Unknown Number" on the screen I want to change that per port is that possible? to say "company A" ..this is assuming you are using MGCP as we are.

This is Call Manager 4.1 I understand i can point them to diff DN numbers, but they would like it to ring the same Dn , How do you Label the incoming call?

I have a site that we have two business running from, I have two different hunt groups (from the phone company) for both business. The Question is I Need to have the incoming calls say the name of the business they are calling. I have 2 FXO cards in the router. 4 analog lines per company. How...

thank you all!

All I'm after is the support and firmware for the 7921. I dont want all the other phones getting new firmware at this point. I'm guessing I need to install this on pub first then install it on sub?