Recent content by jabst

Thanks,

Where can I find this REQ: prt TYPE: dnb CUST 0 DN 1 DATE PAGE DES DN 1 TYPE SFP

I'll remove it in the morning and look at it, since the tty's are ctyp are quad sdi I will probably need a new one Thanks,

At the back of Core 0 I have J13 J14 & J15, J15 has a label tty01 next to it, My ACD print is on tty 2 which is connected to J14. J13 says Critical I on it. So I assume I dont have a tty 4 to connect to. Does that make sense?

How can I tell?

tty 4 >ld 37 IOD000 .stat TTY 0 : ENBL TTY 1 : ENBL TTY 2 : ENBL DES: ACDPRTR TTY 3 : ENBL TTY 4 : DSBL DES: CDR TTY 5 : ENBL TTY 6 : DSBL DES: elman1 TTY 7 : DSBL DES: elman2 TTY 8 : ENBL DES: elman3

Ok, back in now and here is the ADAN REQ prt TYPE adan ADAN HIST SIZE 20000 USER MTC BUG ADAN TTY 0 CTYP QSDI DNUM 0 DES FLOW NO USER MTC XSM YES TTYLOG 0 BANR YES ADAN TTY 1 CTYP QSDI DNUM 1 DES FLOW NO USER MTC TRF SCH BUG...

I lost all access to the system, I can get in through element manger.

I built a tty port and when I enl tty x I get IOD006 Must I ini the switch before it will come up? Thanks,

Yes, Found out the vendor that installed changed from 2/6 split to 3/5 with out a cold reset, I am installing a new hard drive due to the data corruption. Thanks,

I have a BCM 400 upgraded from 3.7 to 4.0 2 years ago, Company implemented 66 IP phones 6 months ago, I have been plaqued with problems since. 58 phones registered and 48 can 4 digit dial across network, the rest cannot. Delete those phones and reprogram and still cant dial. These 10 in Monitor...

ok, thats the way I programmed it. thanks to everyone for your input!!!!

Ok, I removed key 2 & 3 from the five phones and then added key 2 & 3 with lhk 4 on tn 65 5 and then tested, it worked fine, and the I I did the same for the rest of the phones and tested and is now working fine. Question I have now is when adding the keys I started in the middle of the tn range...

Yes, 5 ext's have 1111 as key 2 and key 3 is 1101,

OK, changed to LHK 4 and I still get a busy while talking to 1xxx and call from my cell, any ideas. Thanks,