Recent content by dreadtek

It's an option 81c.

Ok I found another terminal to use, a VT420...BUT it was doing the same thing, so I kept playing with the settings and found a couple that finally did the trick: Transmit and Receive at 9600 XOFF at 128 7 BITS, MARK PARITY 2 STOP BITS COMM1=DEC-423 However, strangely before yesterday the only...

That is the only terminal I have available. How do I change the baud rate on it if I only get these mismatching characters when I type anything in?

I have tried using the VT520 terminal and have also remoted in through a modem and used PuttyTel on my PC, in both instances what I type in does not match what is being displayed. For example, when I hit the enter key, I get ^M come up on the screen. I was using the PBX terminal all day without...

KCF I understand but how do utilize LD20 in order to delete FDN and HUNT?

Since thread798-1646528 has been closed. I wanted to ask, where are those commands to be inputted? Under which LD? Thanks

It doesn't show disabled on the PBX.

KCFLHRC, is it possible any of those bad items kill a TN???? It's as if it's shorting out the TN somehow.

I've moved a phoneline from a dead TN to 2 different "working" TNs and it works for an hour or so then that TN dies. What would cause a phoneline to continuosly kill the TN it's on??

What's the command for MCR?

Trying to do it without a 2nd DN to avoid billing complications. Is a 2nd DN necessary?

I have an m2616 that needs to be configured to show caller ID on incoming calls while the user is on the phone. Enduser only has one DN on both key 0 and key 1. Right now when the eu is on the phone and someone dials, it goes straight to voicemail and caller ID is not displayed. How can we fix this?

yep got it fixed look at post above yours

KCFLHRC THANK YOU SO MUCH!!!!!!!!!!!!!!!! THESE OPTIONS WORKED~!!!!!!- 2400 BAUD 7 and 2 Parity Mark

It is connected to TTY2