I have an m2616 that needs to be configured to show caller ID on incoming calls while the user is on the phone. Enduser only has one DN on both key 0 and key 1. Right now when the eu is on the phone and someone dials, it goes straight to voicemail and caller ID is not displayed. How can we fix this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Show caller ID for incoming call while on call and stop it from sending to VM
- Thread starter dreadtek
- Start date
First setup another DN (as rollover) then change CLS of ADD (allow digit display) to be TDD (tandem digit display) and be sure to change DNDA to DNDD (otherwise it looks like you are calling yourself). Then you need to alter LHK (last hunt key) to be whichever last key your DN is (1) typically. This should allow a call to ring to the rollover line when your End User is busy on the first line and display whom is calling so they can decide if they need to answer before it goes to voicemail. Also, you will need to add the second DN into voicemail.
For example
key 0 scr 1000
key 1 scr 1001 -- this is ur last hunt key
key 2 msb
For example
key 0 scr 1000
key 1 scr 1001 -- this is ur last hunt key
key 2 msb
- Thread starter
- #3
bdmcdonald99
Technical User
Yes
It's a phone system, NOT a clock!
It's a phone system, NOT a clock!
mlozoveanu
Technical User
Try MCR on both key, because has the same DN on key 0 and 1.
- Thread starter
- #6
norstarboy125
Vendor
Instead of the key being scr it would be mcr ( multiple call ring )
Key 0 mcr 1000
Jeremy J. Carter
Charm City Communications
Norstar. BCM. CS1000 Programmer
Key 0 mcr 1000
Jeremy J. Carter
Charm City Communications
Norstar. BCM. CS1000 Programmer
- Status
Similar threads
- Locked
- Question
