Recent content by DogBiscuits

I am getting the following error: "The program can't start because Watchdog.dll is missing from your computer. Try reinstalling the program to fix this problem." Any ideas?

Thank you very much.

I need the admin tool for a CS-5200 version 3.2.4.79

OK, That is what I will do then. It has just been a lot of change and I was hoping to keep things as simple as possible. They came off an old Nortel Symposium express that was failing and dropping calls. They freaked when I installed the desktop client :-)

Is it possible for more than one agent to use the same phone in uccx? Let's say you have first and second shift employees that use the same phone. Or a fill-in agent that logs-in while someone goes to lunch... etc I don`t want to use extension mobility if I can avoid it.

Peer Details: context=from-pstn fromdomain=callcentric.com fromuser=1777XXXXXXX host=callcentric.com insecure=port,invite secret=XXXXXX type=peer defaultuser=1777XXXXXXX disallow=all allow=g729 Register String: 1777XXXXXXX:XXXXXX@callcentric.com/1777XXXXXXX

Scratch that. It's still not working inbound. callers can hear me but I can't here them. I registered a sip client to the asterisk box and called the CME and it worked fine. I can call the asterisk extension too and everything works. I can call outbound from the CME to my cell and...

I found the problem. I needed to disallow all and allow ulaw on the asterisk box for calls coming to CME. I purchased the G.729 codec from Digium and used it to setup my connection to callcentric.com. So I guess it was passing G.729 to CME when I received calls. Once I forced G.711 it seemed...

I setup Asterisk now with callcentric and registered my CME to the Asterisk system. I can place calls fine. two-way audio & DTMF work great. However, I am getting 1-way speech on incoming calls. Here is my current CME config: sh run Building configuration... Current configuration : 2337...

Hello, I have just configured a sip Trunk to callcentric.com. I am able to place calls inbound and out but there is no audio. I think this is part of the problem. "CME2600#show voip rtp connection VoIP RTP active connections : No. CallId dstCallId LocalRTP RmtRTP LocalIP...

I set SUPN=yes on the Trunks, but it had no affect. I changed the EOD timer and that fixed it. Thanks to you both!

Opt11C Rls 25.40b Analog Grd Start Trunks M3903 & M2008 Sets When users call an off PBX Conference Bridge they are prompted to enter their pass code them press #. When the press # nothing happens. If they press it again it works. I turned on the call timer on the 3903 and noticed that the...

I have experienced this before and for me it was a CLID issue. I was sending inccorect CLID and I got dialtone back from the carrier. Once I corrected the CLID the problem was resolved. Check your CLID and see if it isn't wrong on the affected sets.

Never-mind. Just found it in the NRS Installation and Commissioning Guide. Sorry.

Can you Bulk Add NRS routes on RLS 5.5?