Recent content by DisasterMaster

It's the same config between both sites. One site works and the other doesn't. I restarted IPVMS service which didn't make a difference either.

hmmm, guess no one seen this before. If I find a solution, I will post it here for future reference.

I have a Cisco VG port connected to a BOGEN PCM2000 paging system. Trying to find root cause to the following intermittent problem. 99% of the time the system works as it should. Dial access code, hear a beep, dial zone number, hear a beep and then make announcement. On occasion though, I can...

I have both AQM & Calabrio One 10.4 call recording servers that I auto record calls to. Using 8841 & 8851 phones on CUCM 10.5. When the phones are on our LAN, call recording works great. When I take the same phone home, connect it to a Meraki Z3 and tunnel back to the office I have recording...

Yea, after I create an Adam, the next step after that is to create an Eve. Actually, I figured this out. The format for DLOP is Loop/#of Channels/Framing.

All Loops in my switch are configured as PRI. When printing CEQU in LD 22, some show DCH as 23 and some show DCH as 24. I still don't understand or can find documentation that states what the DCH value is actually referring to. When adding a PRI in LD 17, I see no parameter that references this...

No NFAS here. All my circuits are PRI that have their own D channel. This particular PRI is going to be configured as a TIE line to a Cisco router. I will be using a UDT card that has yet to be placed in a 1010 shelf. I know once I install the card I will need to make a serial connection to...

Below is a screenshot of CEQU on a release 7.6 cs1000e. Why is the DCH value shown on some PRIs as DCH 23 and some 24 and how do you change the value. I just added PRI Loop 84 and it automatically set the DCH as 24. I don't recall a parameter in LD 17 that allows me to define 23 or 24. Does...

I’m working on a CS1000e release 7.6 and noticed that some of our 1140 IP phones have the correct time on the phone display however missed calls shown in the call log are off by 4 hours. Is there a fix or patch related to this?

PSTN SIP Sucks. IMHO, it's not ready for prime time. Most carriers can't do T.38 faxing on it either.

Thanks for the feedback. I will read thru this ASAP.

I'm trying to find a place that is a Nortel/Avaya Blue shop and still make the money I do today. I can work on both Cisco and Avaya. Cisco is OK as long as you stay away from SIP. It's one constant issue after another. A real pain. I getting to old for this Cisco crap.

It’s a 2250

Never mind. I figured it out.

Is there a way on this site to pull up a list of all of the posts that i have made over the years?