There was a 24-port version a long time ago.
There were also DLC48 (48 port version) used on 11C mini, it went in physical slot 4 but was programmed as 3*16 in slots 4, 5 and 6 (that's why older CS1000e chassis don't have physical slots 5 and 6). These broke out on 2 Amphenol connectors - 24...
The PCMCIA cards are similar to the ones used on laptops, hit the eject button beside the card and they'll pop out.
Formatting them on a windows PC sometimes gives problems - you can just remove and dispose of them, not needed for operation.
To remove all data (to US DOD standard or similar)...
QPC536 is very old (have to dig out some training manuals for more info) but it uses an eNet to get traffic on/off the backplane and may also wire out to clock controller cards so the switch can be sync'd to the carrier.
DTI is Channel Associated Signalling (CAS), no DCH so no MSDL needed...
Also do a few saves (LD 43, then EDD a few times) when you've done the wipes.
You may also want to remove/blank any PCMCIA flash cards installed in the faceplate of the SSC (beside the power supply in the main cabinet - should be marked SSC or NTDK20xx) as archived data can be stored on those...
@perrypj
For UK switches we (should!) always allow 112 and 999 emergency numbers for all NCOS/FCR. Good call as it never hurts to remind people!
Senior Engineer, cmass
www.cmass-ni.com
If e-auth codes you do need to ensure partner has done their piece properly, we did an audit on a large switch recently and customer realised their local partner hadn't applied all the authcodes that they'd ordered.
For normal expansions you should get a shipment with a new license sheet, at...
If e-auth codes you do need to ensure partner has done their piece properly, we did an audit on a large switch recently and customer realised their local partner hadn't applied all the authcodes that they'd ordered.
For normal physical upgrades you should get a shipment with a license sheet, at...
Seems a bit long, switches at release 5.0 and above can use the electronic auth code process in KRS so there's nothing to ship. Chase the supplier :-)
Senior Engineer, cmass
www.cmass-ni.com
Could be someone has changed the TTY settings on the processors (each "J25" has its own TTY) - baud rate, flow control or similar.
Print them in LD 22: REQ PRT, TYPE ADAN TTY and check.
From memory the processors have CTYP=CPSI.
If you can access PDT on that core it could just be the TTY is...
Can you resend this at a lower logging level? It may be possible to see something in the human readable forms (not sure what decodes at that level but worth a shot before asking people to decode hex dumps).
LD 96
SET MSGI 0 MON 0
SET MSGO 0 MON 0
Senior Engineer, cmass
www.cmass-ni.com
From memory there's a PI patch that drops the H. We saw this inside the Nortel voice network way back when some users called from a soft phone.
Senior Engineer, cmass
www.cmass-ni.com
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.