Recent content by bmarino59

Phone is on one side of wall. we needed speaker to be i center of kitchen and loud. I agree with budbyrd. I needed to expand my IPO with analog loopstart, will keep you all posted when connected.

My resident are using regular analog princess phones. Will that make a difference? I want them to be able to call the kitchen using this line, and have the kitchen employee speak without having to pickup the phone, using the Valcom 9941. Hope I'm making myself understood, I apologize if i'm...

Thanks Tommy, I will give that a try. What are you referring to when you say its not bi-directional? Station Port programmed as page-port or UTI1?

Hope someone can help. Trying to setup a Valcom V-9941 Handsfree speaker on my IP office 500 9.x. The V-9941 unit supports either a loopstart or pageport with contact closure. I need to be able to page using an extension, this is because we have residents using analog phones in their rooms...

Crossover cable needed. Working fine!

Ok had Comcast monitor the circuit. They are saying that my system gave "bye" signal when they saw the drops.

Hi all, Recently installed an IPO v9.1. Been up and running for the past 2 months relatively no problems except for sporadic dropped calls. I have monitored using System Status. For example, my call was dropped but no others. I little while later another call was dropped. Does not happen all the...

Just want to make sure, you are referring to System Status under Active Calls?

Currently configured as NI-2. We have the same pri's at two other locations with BCM's(which I am migrating to IPO) and they send location as well as number, and I am certain those lines are configured with NI-2 as was this location. But I will double check. Thanks for the information.

Hi all, I have new IPO 500 v2 installation. It has 3 analog and 1 T1 Pri 23B+D. I created a system shortcode 9N Dial NSi7815551234 50:Main I also created a shortcode for my extension 9N Dial NSi7815557878 50:Main Is this correct? Also, will the CLID display the description? For example, Bob...

I tried again tonight but with a new cable. Strange, it worked. I was able to call out and receive a call to my extension. Only the number that showed up on my cell phone was not the number I want to show up. How do set the correct caller id number coming from my system? Thanks again!

Tested with loopback, LED: green flashing Also spoke to the tech who installed the system. He said, "Sometimes you have to put the channels out of service and then back into service after the circuit is connected. If you click on the channels tab, you'll see a list of channels. Select all the...

Thanks Tommy, Also found info on how to create lookback. Will test tomorrow.

How do I create a loopback plug? I will check my current cables pinout. How would I know if its a cross or not? Thanks for the help!

I'm switching from a BCM400 to IPO system. When I tested the line this past Saturday night, it didn't work. I plugged the line into the correct IPO port, the LED on Comcast equipment stay red. SWITCH TYPE: NI2 CHANNEL ALOC: 23>1 CLOCK QUALITY: NETWORK HAUL: 0-115FT LINE SUB TYPE: PRI ADMIN: IN...