Recent content by bettyr

me too. same problem

I have the same issue: CCC on Win Server 2003 and Exchange on seperate Win 2003 Server.

Using IMS on an IPO406v2 (3.2.17) and VMPro (3.2.15) No noticable problems but receiving the following warning in the application log. Event Type: Warning Event Source: UMServer Event Category: None Event ID: 3 Date: 8/30/2006 Time: 6:15:31 PM User: RTELEPHONE\vmpro Computer: NTSERVER6...

get rid of the third CA button (c=) and add RESERVE_LAST_CA=1 to the source of to the NoUser account. This will allow only one active incoming call on the set.

Go to: http://support.avaya.com/elmodocs2/ip_office/jobaids/002_dte_port_maintenance.pdf 1- Switch off power to the IP Office Control Unit. 2- Power on the Control Unit and press the escape key every second until you get a Loader message. 3- Enter AT (note upper case). The Control Unit should...

or almcall from a bash prompt if using an S8x00

connect the telephone line to the last (violet/slate) pair of the AUX cable at the MDF.

I have a similar situation in CRM 3.0 where the account telephone number field is typically entered as XXX-XXX-XXXX The IPO will send it as either: 9XXXXXXXXXX (with the Line Prefix set to '9') XXXXXXXXXX (with the Line Prefix empty) If I enter the CRM telephone numbers as XXXXXXXXXX it works...

What is mobile twinning? Can it be used with loop-start trunks?

Sounds cool, when is 3.2 coming out?

Good post. Thanks.

see also http://www.reillytele.com/AlarmTraq/Docs/s8700_oss_setup.htm

1. Log into CMS as root2 or cmssvc. 2. To verify that the required packages are installed, enter: pkginfo -x | grep LU Verify that the following packages are installed: • LUahl • LUaot • LUim • LUorbutil 3. To obtain the cms version, enter: pkginfo -x cms 4. To identify the communications...

This works on my IPO406v2 3.1(29) using a 5420 telephone. 1- Have someone dial your extension. 2- While your phone is ringing, press a second call appearance button(b=) and get dialtone. 3- Now press your MESSAGES button and it should show: ____________________________ >NEW=1 >OLD=3 >SAV=7...

Look at http://www.reillytele.com/AlarmTraq/Docs/s8700_oss_setup.htm