Recent content by atbw3

if we have a route with acod 089. ( 089 is the acod for mobile telephone). now if i want to dial to mob. phone : first i need to dial 089 to get the line . then again i have to dialthe mobile number 089 xxxxx. my question how can i dial just once 089 to get the line and to concider it as...

check the alarms on the card , cuase i have the same problem, the reason that there is a far end alarm on the pri card wich cause that the channels stay DSBL.

could u pls. give any specification for apower adapter. volt ? amper ?

Ok , good solution to change 0 to 00, but but also what i need how to use the 089 as apart of dialed digits, using i think the RLI ,del & insert digits. if possible pls progrming steps.

from where you gotS 900 meters? I`ve looked in the NTP`s but found nothing point to the distance/ othe thing is it right tha it needs 2 pairs for 2 digital TN`s programmed as 2250 , and the third digital pair ( w-s) for power, no need to programe the third TN???

need help how to program direct acod 089 & 088 to access mobile tellular root then immidiatly to dial the dest.number. what i mean if i want to dial from my mobile phone i will dial 088xxxxxx or the other mobile company is 089xxxxxx.a from the Option 11 I creat 2 roots for them with acod 50...

what should be the max. distance between the PC console & MDF? in our case the distance about 45 meter with a one peice cat5 cable but it is not work, it expermented near the MDF it`s work perfect. thanks alot

in ld 18 new type scl lsno ( list no ) TYPE: SCL then start to stor the code and the nomber wich you want to store. following is print for scl. LSNO SCNO 0000 SCL DNSZ 4 STOR 0 STOR 1 STOR 2 STOR 3 STOR 4 STOR 5 STOR 6 STOR 7 STOR 8 STOR 9 SCNO 0001 SCL...

ok tomorow i will try the SCR. Thanks alot.

the reoson why we use the MCR scenario that we dont have 2250 cosole so we use it as an operator. TN 003 0 00 02 TYPE 3904 CDEN 8D CUST 0 KBA 1 FDN TGAR 17 LDN NO NCOS 3 SGRP 0 RNPG 19 SCI 0 SSU LNRS 16 XLST 5 SCPW 9941 SFLT NO CAC_MFC 0 CLS TLD FBD WTA LPR PUA MTD FND HTA TDD HFA GRLD...

this is how the keys are programmed: KEY 00 MCR 531 0 MARP CPND CPND_LANG ROMAN NAME XPLN 27 DISPLAY_FMT FIRST,LAST 01 MCR 531 0 CPND CPND_LANG ROMAN NAME XPLN 27 DISPLAY_FMT...

Thanks alot , all of you deserve star.

yes we running CS 4.5, the customer wants us to download the firmware software from Nortel site, my question how to insert this softwere to the systym or to telephone directly ??

sory ; what do you mean by marped ?

the i2007 phone is in service, a the customer gets new firmwere software & wants to load (upgrade)it to his phone