Recent content by alphi

Oh,Thanks Whykap 'Press the "transfer" key again' ;It helped me ,now it works fine

Is there anybody who tested integration between NCH IVR (http://www.nch.com.au/ivm/) and cisco callmanager. It is very good & cheap prodcut for voicemail ,IVR,Auto atendent.and it supports voip protocols. any comments??

I have a call cenetr with 5 agents,running CCM4.0 with a Cisco 2620 router (4FXO,Running MGCP). everthing is Ok,but I have problem in transfrring call from outside.I mean, I can transfer internal calls ,but when a customer calls from outside and an agent wants to transfer the call to another...

I am going to use Cisco IP Communicator with CCM 4.0,but there is no option in CCM4.0 for adding Cisco IP Communicator.Please help me on this.

anything else,please help

I don't have VMail,what should I do?

Is it possible to set in CCM maximum number of rings? for example ,if the phone rings 5 times and no response,call automatically disconnect.

OK,Now I don't have any problem with dial peer.I receive calls on my 500 hunt group and call dial ou with 9.!; 1-I have problem with FXO Disconenction,In MGCP mode when I set the cptone to DE it worked,but in H323 it dosn't work,any comments? 2- I don't receive Caller ID on my ip phones,I am...

Very Thanks, Now I receive incoming calls on my IP phone (extension 100) and I can dial out with 9.!; I am going to replace 100 extension with a hunt group pilot number 500;I have assigend 5 extension to 500(100-104); I am using "connection plar 500";but it dosen't work.Do you any comment?

I started configuration of my router to use as H323 gateway. I have no problem in outbound calls,but when I dial the number which is connected to my FXO ,I hear fast busy. I am going to forward all calls from PSTN to extension 100 on my call-manager . Here is my configuration file,Please help...

I am disappointed from MGCP, I am going to test it with H.323.but need help to configure it,Please help me how to configure it

Yes,Fast busy on the phone,how can I debug it?

please send me links or example configuration

I have installed Cisco Callmanger 4.0 with 10 extension(100-110) I have a cisco router 3661 with 8 FXO.I want to configure this router as a H323 gateway (not MGCP).Which configuration is needed to receive all my incoming call on extension 100,and route my calls through a free FXO line. and how...

It is not matter of routing paln,because it was working with 2600 router,something is wrong in my router?how to trace & find this probelm?