Recent content by adamf53

Hello Quick Question... Why is it that Domain Users can remote into a server 2003 box when they are not listed on the Remote tab? Only domain admins are listed, yet a Domain User can login ONLY if the server is logged off.

Has anyone seen these errors? This is actually from the BCM side. The IP's listed in the error are the mgc's in the cs1000. This error is on every BCM in the network. Anything to be concerned about? No quality or dialing issues. ResourceMediaController::(OID=0x8173f68) Transport mismatch...

Ran option

Scenario; Symposium Express is setup to be open from 9am to 1pm. Due to snow, ice, etc. agents are unable to come in. Is there a way to setup Symposium to send callers to a recorded message if no one logs in during service hours? I tested this using the "Skillset out of service" option...

Is it possible to export Voice items from Callpilot? I see many options for Importing voice items, but none for exporting. Can anyone share if it's possible? Thanks

Hello; We have callpilot fronting the calls on our symposium express setup call center. Call pilot just forwards to the call center DN based on time of day. Time of day corresponds to the call center service hours (typically 9 - 5). Is it possible if none of the call center reps are logged...

I gave you a config from a wrong switch, here's the correct; interface GigabitEthernet0/19 switchport access vlan 114 switchport mode access switchport nonegotiate switchport voice vlan 170 priority-queue out mls qos trust dscp spanning-tree portfast

Port Based QoS in the LAN & also WAN QoS on the cisco Routers. Below is an example of a port with an 1140; interface GigabitEthernet0/9 switchport mode access switchport access vlan 2 switchport voice vlan 55 mls qos trust cos spanning-tree portfast

Yes sir

Version 6.0.2.05.237 BCM monitor doesn't show any lines busy but will check the next time it is reported so I can look at that exact moment.

Hello; We recently installed a BCM50 to replace a 450 and are having only 1 issue. Just as a background this system has a local PRI and is connected to a gigabit LAN and talks to the CS1000 over a dedicated T1 network. Our issue is that at this site, for no apparent reason, a user's 1140 IP...

Hello; I'm having alarm problems between 11pm and midnight and wondered if there was an "event log" on the option 11? If so, can anyone share the ld # & command(s)? Thanks in advance, Adam

Fixed... Evidently you have to install with the R2 discs vs. regular Server 2003 discs. Adam

This is driving me nuts.. I've got a new server w/ 2 146GB hard drives setup in a RAID 1 array. I'm trying to install Server 2003 using Dells Server Assistant (have used on 20+ servers no problem). After its finished and I login, I don't see my desired partition of 30GB for the C:\ drive, I...

Hello; My DNS server isn't deleting old records and I can't figure out why. Can anyone shed some light? Workstations that haven't been on the network in a year are still showing in DNS. Any suggestions would be greatly appreciated. THanks