Recent content by AC427

Hi, I have a 2901 router which is showing some odd behaviour. During the evening/night/weekends when there is no load on the CPU or WAN link the response times to the router over the network becomes quite high, anything between 200 - 600ms. The normal response time during the day when it is...

Hi, I have a PRI circuit between 2 Option11s and am getting the following error at one end PRI2 LOOP 1 - ENBL REF CLK: ENBL TRACKING SERVICE RESTORE: YES ALARM STATUS: OOS LOCAL ALARM : LFAS CH 01 - DSBL TIE VOD * CH 02 - DSBL TIE VOD * CH 03 - DSBL TIE VOD *...

This is the trunk that i dont get busy tone from YPE RDB CUST 00 DMOD ROUT 110 DES EURO ISDN TKTP DID NPID_TBL_NUM 0 SAT NO RCLS EXT DTRK YES BRIP NO DGTP PRI2 ISDN YES MODE PRA IFC EURO CNTY UK SBN NO PNI 00000 NCNA NO NCRD NO ISAR...

There is no loops etc as the only place it has been forwarded to is itself or no forwarding at all. After further testing i have found it gives busy tone on internal calls and from an IP incomming call, so it looks like it might be a trunk setting.

someone has advised me it might be a setting called Treatment somewhere in ld 15 CDB. Any ideas if this is an option and if so where?

Hi, Thanks for the advise, but neither worked. I was initially thinking it was just with this set, but its the same on others, so im now thinking its a system wide issue. is the busy tone set in the trunk anywhere perhaps?

Hi, Im sure this is a simple issue and its staring me in the face. I need a 3902 to give busy tone when its busy. At the moment all it gives is the continuous dead tone when the phone is in use. I have tried the phone with no forwarding of any sort, just FDN set to forward to itself and all...

Hi, Both Meridians have the following in NET DITI YES TRNX YES EXTT YES FTOP FRES and neither have XFA in the CLS as they are digital exts, my understanding is that is a 500 set CLS.

i finally got to the bottom of it. I removed SPN 00 and allowed SPN 0 to dial 17 digits and it now works. Thanks for the advise though.

Ive already tried UNR and that didnt work. The thing that concerns me is that the Meridian is letting him dial out but only seems to be sending the 00 part of the number.

This is the only phone on the Meridian that has ever been allowed to make international calls so i cant compare it to a working TN unfortunatly. The international number being dialled is the correct number as it works from other places. The number being called is 00 353 xxx xxx, so its not...

Hi, I have a single 3903 set up to allow international dialling but it has stopped working. The NCOS allows international dialling and i have tested this by changing the NCOS on the set to a different class. When it has a international barred NCOS it doesnt allow the call, but with the allow...

bump. thanks for the advise so far, but none has worked. Any other suggestions?

Thanks for that. Ive looked at both systems and they both have the following set CDB Net Data TRNX-YES EXTT-YES A set from the system that can transfer has FTTC in the CLS and a set from the system that cant has FTTU. So neither of these settings seem to be the one that is stopping the...

Hi, I have a customer with 2 Meridian Opt 11. running 25.15. On both systems they can call mobiles and national numbers, but one cant transfer calls to mobiles and national calls. They want this implemented on the other, but i have no idea how thats set up. My understanding was that when a...