Recent content by 32321111

What are you recommend?

Hi folks, Here is my question. How hard is it to migrate from 5.1A and Pervasive 8.6 to 5.5 and SQL Express. Database size is 1.2GB There is any problem or issue to jump to 5.5? There is any work inside the Accpac or just database dump? Thks

Hi guys, I'm having some problems to load a new template in my server I have a brand new SBS and when I try to create a new site "Sites and Workspaces" and select the template and hit OKAY. I get this error message. The template you have chosen is invalid or cannot be found Anyone can help...

Jay, Thanks for your help. I did everything you said. I had to remove another application that has use Crystal and after remove the workstation setup, reboot and reinstall everything went fine. Thanks a lot Mark

Hi guys, I hope you can help with this problem I have. VERSION: ACCPAC 5.1A, PERVASIVE v8.6 and MSXML 4.6 SP2 I installed a new computer with accpac, I followed the same process that I had done in all computers that has accpac (they are working fine). But this computer isn't working when I...

I found the problem. On of my sites is missing a CALLER ID ADAPTER. So because that a few calls show names and a few show numbers. ps.: All my phones are set up with same settings

There all the same. only the target line is different. each fone has their own target line as PVT.

Hi folks, I have site1 and site2 both have their on system, that is connected by PRI. When I call to a extension number between site some extensions I see Names and others I see only the extension number. How can I enable the name to show between sites? Thanks

Thank you. This fixed my problem.

I have a fast busy signal. So how I reassigned the target again?

Hi Folks, I have a problem with one of my locations can't call to an phone in another location. I have 2 sites SITE1 and SITE2 SITE1 can call all the extensions in SITE2 SITE2 can call all the extensions in SITE1 There is 1 extension number that SITE1 can't call SITE2 returning busy signal...

If you set the protection to 7 days. It's 7 days after the job is finished. If the job finish 2:00pm 28/03/06 you count 7 days after that. I'd recommend you use 6 days overwrite for you Friday Full backup

Make sure you have the disablelastaccess ENABLED on all servers. This option is the key that sets the Bit ON/OFF every this you do the backup. by default this is ON. to enable it go to prompt command and type fsutil behavior set disablelastaccess 0 This option don't affect any application...

You could enable the Domain Controller to force the logoff after xx hours. I have this setup for a few departments that always let the computer on all night

Tell me more about it. How many data are talking about? What is your BE version? What is your Tape Drive model or library?