Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Zebra 90xill Printer

Status
Not open for further replies.

podocnemus

Vendor
Feb 24, 2010
6
GB
This printer was working okay, but now misses every other label. Otherwise working fine

Using Nice drivers. checked label size is correct for printing

Have removed and re-installed drivers

Have cleaned the media sendsor

Using XP 64 bit

Before I send this into orbit can anyopne please help?
 
Hi

Clearly no-one has had this problem on this forum

can anyone suggest an alternative forum???

Must say its a very frustrating problem
 
I am not familiar with that particular printer, but ...

Perhaps this is a 64 bit issue

Perhaps this is an issue with your application and not the driver

I notice that the printer does 300 or 600 dpi?? If that is the case, try changing the resolution and see if that has any effect.

Is this a "window only" printer, or can you program it using a zebra printer language like ZPL II?

As a last resort you could try calling Zebra tech support. On the couple of occasions where I needed some clarification, they were VERY helpful.


Jim Asman
 
Thanks for the suggestions

Used different computer and loaded different drivers (seagull)

Printer can be programmed with ZPL 11 but have never done so

Have used sifferent software

Zebra do not want to know as this is now an unsupported printer

Still no luck in solving problem
 
Hi

I did a media calibration and a media/ribbon calibration to no effect
thanks

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top