Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Why is my PRI showing MBSY on all channels? 1

Status
Not open for further replies.

zigmo36

Technical User
Oct 19, 2009
114
US
I keep disabling the DCH in LD96, then disable the loop in LD 60, then reenable both, keeps showing MBSY on all channels. What am I missing? Thanks!
 
So when you enable the DCH do you see an establish message? If you stat the loop in 60 is there an error against the PRI same if you LCNT the loop.

Probably the easiest way is to reset like this:

LD 96
dis dch x

LD 60
disl x
rcnt x
enll x

LD 96
enl dch x

LD 60
stat x
lcnt x

post the stat and lcnt results
 
Thanks for your response, Bignose21! I did just as you suggested:

PRI* TRK Loop 12 - Enbl
FFMT/LCMT/YALMT: ESF/BBZ/FDL
Service Restore: Yes
Yel Alm Processs: Yes
Alarm Status: No Alarm
Ch01-MBSY DID 3VCE Ch02 - MBSY DID 3VCE
Ch03-MBSY DID 3VCE Ch04 - MBSY DID 3VCE
Ch05-MBSY DID 3VCE Ch06 - MBSY DID 3VCE
Ch07-MBSY DID 3VCE Ch08 - MBSY DID 3VCE
Ch09-MBSY DID 3VCE Ch10 - MBSY DID 3VCE
Ch11-MBSY DID 3VCE Ch12 - MBSY DID 3VCE
Ch13-MBSY DID 3VCE Ch14 - MBSY DID 3VCE
Ch15-MBSY DID 3VCE Ch16 - MBSY DID 3VCE
Ch17-MBSY DID 3VCE Ch18 - MBSY DID 3VCE
Ch19-MBSY DID 3VCE Ch20 - MBSY DID 3VCE
Ch21-MBSY DID 3VCE Ch22 - MBSY DID 3VCE
Ch23-MBSY DID 3VCE Ch24 - DCH 10

PRI LOOP 12
TRSH CNT:
BPV -000
SLIpd -000
SLIPR -000
CRC -000
LOSFA -000
OS_BPV -000
OSLOSFRA -000
OS_YEL -000
 
I keep getting a DCH: 10 Maint. Indication Counter Value 3 64 19 255
 
I usually see that when my carrier has the PRI down, bad cable, etc. If you do get it back it will probably immediately go back to MBSY until the circuit is back to normal. You could through a loop on RJ45 to test.
 
The D-channel stat shows:

DCH 010: OPER AEST AUTO DES : PRI12
 
Thanks very much for your help, my friends! God bless one and all!

Zigmo36
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top