I'm some what familiar with DTI and PRI, but I have been out of this wonderful telephony world and I recently came across this.... TMDI stuff. What it is exactly?
IT'S A PIECE OF GARBAGE THAT NORTEL CAME UP WITH FOR AN OPT 11C, THAT DOES THE SAME JOB AS A DTI CARD. BUT IF YOU WANT TO PUT A ISDN-PRI YOU NEED SOFTWARE DCH'S FOR IT, NO DCH M/B
So if I understand this right, this card only fits in an OP11? Would you happen to have a card number? What about the DCH card?
I have an OP11C Rlse 25.40 that I want to link to an OP81C Rlse 25.47 using ISDN PRI. Since it's been a while, a little help with hardware requirements and programmation would be much appreciated...
You are correct. You cannot purchase a new DTI card any longer. We have a couple of those new TMDI cards in our 11c PBX now and I'll get you the part number when I get back to the office on Monday. I just bought one like 3 weeks ago.
If your switches are in the same building and you are going to connect them directly with a shielded T-1 cable between the floors then you don't need a D-channel card. You can program the pbx on both sides as a regular ground start T-1 with 24 channels. I could give you the signaling information if you want it because I have this setup as we speak.
If your PBXs are in two different building locations you could order a ground start T-1 from bell and you will still not need a DChannel card because you'll be using all 24 channels. Signaling information would be the same as if your pbxs were in the same building.
If your PBXs are in two different locations and you are going to use a PRI T-1 to connect them then you'll need a new DCH card. But since the two PBXs are just going to be tied together for call transferring I'd just get the regular ground start t-1s. You'll get an extra channeling out of it. That's what I did and through the use of the coordinated dialing plans it worked great for 3 years.
The TMDI card can be used as both ISDN and non-ISDN.
May be ur switch is using the TMDI as non-isdn (i.e. TDI)
But both required d-channels for PRI. PRI requires a separate d/b or msdl card while TMDI only requires s/e licesnse.
Thanks guys for the info. I wouldnt mind a little extra help as far as programming and hardware requirement. One question: If I setup the link as DTI, would it pass along CLID between the two switches?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.