Whenever someone wants their automation to have the same option number as the starting digit to their extensions, what is the best way to set this up. In the past if a customer starts off their automation with "you may dial your extn at any time" (and say their extn range was 400-499) then we would leave option 4 off the automation. and make a 4?? go to a $KEY. There is probably a simple way to have both, but I just dont know it. Any suggestions would be appreciated!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
VMPro 2
- Thread starter 4vayaMan
- Start date
-
1
- #2
-
1
- #3
Kyle Holladay
ACSS SME Communications
ACE Implement: IP Office
MCP/MCTS Exchange 2007
Adtran ATSA, Aruba ACMA
"Thinking is the hardest work there is, which is the probable reason why so few engage in it." - Henry Ford
CaptainAwesome
Programmer
@kholladay
Yep pretty much how I do it.
Westcon SR. Engineer
ACSS Net+ A+ CVE RSA
Yep pretty much how I do it.
Westcon SR. Engineer
ACSS Net+ A+ CVE RSA
@CaptainAwesome. Tried to look at yours but it didn't come up for me :-(
Kyle Holladay
ACSS SME Communications
ACE Implement: IP Office
MCP/MCTS Exchange 2007
Adtran ATSA, Aruba ACMA
"Thinking is the hardest work there is, which is the probable reason why so few engage in it." - Henry Ford
Kyle Holladay
ACSS SME Communications
ACE Implement: IP Office
MCP/MCTS Exchange 2007
Adtran ATSA, Aruba ACMA
"Thinking is the hardest work there is, which is the probable reason why so few engage in it." - Henry Ford
- Status
