Viking BLK-4/EWP with 3300

[AlphaMann]

Anyone setup one of these guys with MiVB 9.X controller?
This is old school and have the general idea but any pointers would be appreciated.

Thanks,

 

[Billz66]

looks like its an analog device - would probably have to be connected in parallel with an analog extension and is triggered by the ring voltage

i don't believe it would be able to be used alongside any form of ip device (sip or minet)
- pretty sure there are sip versions that could be used for that - would connect it a generic sip extension to the device and put it in ring all ring group with phone



If I never did anything I'd never done before , I'd never do anything.....

 

[AlphaMann]

So you figure and analog extension and not a trunk access then. I will give that a try.
It is an existing device from and old Avaya that I think is using a Relay Port for contact closure.....
Thanks,

 

[Billz66]

looks like it works on Exchange line or analog phone

https://vikingelectronics.com/wp-content/uploads/BLK-4.pdf

img

https://res.cloudinary.com/engineering-com/image/upload/v1671776866/tips/blk-4_qf3qc5.png

]

If I never did anything I'd never done before , I'd never do anything.....