Our ofc locations having continued problems with faxings. My network guys have confirmed that ports are configured for Cisco Fax Relay, fax passthrough was not turn on – so we turned it on. Any other sugguestions? Is anyone else having a problem with faxing and the VG gateways?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
VG Gateway and Faxing Transmission Errors 2
- Thread starter DL4300
- Start date
-
1
- #2
climbingfool
IS-IT--Management
We have been having faxing problems at some of our remote sites. Try changing the speed settings on the fax machines to 9600 or lower. Some of our multifunctions were set at 33.3 and would connect then just hang idle. If that does not work try routing the call out to PSTN instead of the WAN. We have had to do that with some modem lines.
Hope that helps.
Jason
Hope that helps.
Jason
-
1
- #3
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
- Question