Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

v1 vs v2 power supplies 1

Status
Not open for further replies.

AguaFria

Programmer
Feb 1, 2006
31
US
This is kind of a no brainer - but it caught me off guard on a Hot cut at 2 in the morning. If you have a v2 unit make sure to put the corret earthen ground power supply on it. Other wise you will get a really cool light show on the power indicator - Green - red - off - green - red - off. Basically it ends up being a ground fault warning. A common sense thing - but just a heads up - made my life miserable for a bit. Of course the power cycle doesn't start right away - it took a few hours after all the sets were plugged in and we were starting to test end users.
 
IP406V1 = 45W Psu
IP406V2 = 60W Psu

I would guess that the problem started once you put the phones in & started draining the power

Deffinetly worth the heads up though because it would be very easy to get the wrong jack when swapping units in a rack
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top