UPGARDE A SECOND 6 PORTS EXPANSION FIBER CARD XC 7.0 4

[luisb001]

hello
i try install a second 6 ports fiber expansion card, but. when turn on the power the mics only say "in maintenace". my xc software is 7.0
I have a 6-port card fiber expansion already installed in slot 2 (right) and work fine. but install the second card and only say "IN MAINTENACE"
please help me
thanks a lot

 

[exsmogger]

No reprogramming required. Change the software card first. After the system comes up with the new XC software, then you can power off and add the second 6-port card in slot 1. Your NVRAM should be fine, but verify that it is a release 02 or 03.

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952

 

[luisb001]

to change the sotware card do I need to shut down the system, right?

thanks a lot.

 

[exsmogger]

Yes. ALWAYS power off before adding or removing hardware or software.

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952

 

[hawks]

Just make sure you follow exsmogger direction and do the software first. If you add hardware and software at the same time it will default.

 

[luisb001]

I'm looking for mics xc 7.1 Software with nvram, and find one, that says mics xc 7.1 upgrade kit tools, what is the difference between the two?

thanks a lot

 

[exsmogger]

The XC upgrade tool is only used when upgrading a system from lower than 6.1-XC to 7.0-XC or 7.1-XC. This isn't an item that I sell much. You want just 7.0-XC or 7.1-XC with a NVRAM that is at least release 02.

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952

 

[luisb001]

Thank you very much for their valuable help and time.