Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trunk Diag Menaing 1

Status
Not open for further replies.

plough

Technical User
Jul 12, 2005
279
US
We get a lot of the TRK156 errors.
So as another thread suggested: I did LOVF in LD 36 Cust 0 Rt 0

I am trying to find out what the Meaning of the output is. (What exactly HOLD and RGFL indicates)

TN 4 0 09 00: RGFL HOLD
TN 4 0 09 01: RGFL HOLD
TN 4 0 09 02: HOLD
TN 4 0 09 03: RGFL HOLD
TN 4 0 09 04: RGFL
TN 4 0 09 05: HOLD

Rt 0 are my ground Start COT's....


 
I would test these trunks with a butt set or by direct access, I'd bet they aren't working... post the results
 
Also try LDIC, that is last day incoming call on that trunk.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
Used Maint set to access each tunk and make local outbound call.
Each trunk compelted OK.

 
LDIC

shows all at 0 days.

(these are all first choice outbound - only Inbounds are people returning caller ID calls)
 
disable the card 4-0-9 and re-enable, the stat the trunks and post
 
Before Disable all ports stat IDLE:

Disc 4 0 9

Enlc 4 0 9

All ports stat IDLE

**************************

LOVF 0 0
SHOWS NONE


 
RING OR GROUND DETECTOR FAILURES (RGFL)—Ring or ground
detector changes were not received from the trunk on a large percentage of
calls. On those incoming calls which should have had both ringing and
ground applied, one or the other was not detected.

SHORT HOLD (HOLD)—An unacceptably large percentage of calls on the trunk were held for a short period. Short hold measurement can be set from 0 to 128 s in increments of 2 s.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
Thank you for your help Ace. I think I need to work with the COT vendor on this.
 
This is normally a Telco problem.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top