Transfer button not working 1

[inkiboo]

Running an IP Office system at home (don't laugh) and for some reason I can not the transfer button to work on the 5610s or 1608s but it does work on the one 1616 phone I have.

Pressing the Transfer button does nothing on the phone, other than making a beep, but looking on Monitor it does recognise that Feature Key 4 has been pressed.

Running 5.0(26) firmware.

Any suggestions greatly appreciated because I can't for the life of me figure it out.

Thank you.

 

[Telecomboy]

Transfer requires an open call appearance button (not line appearance) to work. If the phone only has one, a call cannot be transferred.

 

[inkiboo]

And that was the answer! Thank you so much

 

[smokinjoe2938]

well show him some pink then

 

[inkiboo]

Alright, calm down!

 

[smokinjoe2938]

I was calm, notice no caps were used in the making of this comment! and watch your attitude or else people won't be so quick to give you a solution

 

[inkiboo]

My attitude is fine and I was very appreciative of the solution. Thanks so much for the advice.

 

[smokinjoe2938]

no worries

 

[intrigrant]

Thats new for me, is it tested and verified? Must be only on the 9.x versions as before that you needed to have Call Waiting enabled.