Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Transfer button not working 1

Status
Not open for further replies.

inkiboo

IS-IT--Management
Jul 13, 2008
14
GB
Running an IP Office system at home (don't laugh) and for some reason I can not the transfer button to work on the 5610s or 1608s but it does work on the one 1616 phone I have.

Pressing the Transfer button does nothing on the phone, other than making a beep, but looking on Monitor it does recognise that Feature Key 4 has been pressed.

Running 5.0(26) firmware.

Any suggestions greatly appreciated because I can't for the life of me figure it out.

Thank you.
 
Transfer requires an open call appearance button (not line appearance) to work. If the phone only has one, a call cannot be transferred.
 
And that was the answer! Thank you so much
 
I was calm, notice no caps were used in the making of this comment! and watch your attitude or else people won't be so quick to give you a solution

 
My attitude is fine and I was very appreciative of the solution. Thanks so much for the advice.
 
Thats new for me, is it tested and verified? Must be only on the 9.x versions as before that you needed to have Call Waiting enabled.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top