Tone key on M2250 console

[Zaktabu123]

Can any one please help on this? Customer says they had tone key on console which they used for paging . When I ask them if that was PAG and there is no PAging route defined.
They say it was working. Nothing changed except system was upgraded from 5.5 to 6.0.

 

[phonz1]

check the CDB for EEST set to yes

 

[GHTROUT]

Just print the Console out and look for keys that dial a route access code or paging DN.

When you find it, it will be a WAT or COT trunk, or a DN.

Otherwise, find the paging amp, and figure out where it connects to the PBX.

--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--

 

[Zaktabu123]

This is an internal Paging programmed as L500.
Customer said that when they dial 6080 from 2250 console then receptionist would hit the tone button followed by the pager number.
I dont know how it was prgrammed earlier all I see is Key 3 has SSC 0000.

I tried EEST yes it doesn't work


Please help

 

[GHTROUT]

If the customer hit a "Tone" button, that key was called "EES" on the Console TN. KEY xx EES ~~ End-to-End Signaling key (cannot be key 0 or 1)

"EEST" in the CDB is a courtesy tone - just lets you hear tones in your ear. It does not change how anything works. It is not related to your issue.

--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--

 

[Zaktabu123]

Thanks EES key works ...