Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TN799C unable to set to 100mb full

Status
Not open for further replies.

G3siv12

IS-IT--Management
Jan 24, 2007
8
US
The option to change the speed and duplex is greyed out on this CLAN board when I do the ch ip-interface command. I did it successfully on our TN799DP though, had to disable the ethernet port first. Following the same procedure on this board didn't work. Does anybody have any suggestions?

BTW it is running at 10/half right now.
 
As it was said, you can't do it with the TN799C.
It's only with the TN799DP that you can change the spped/duplex of the board.
 
Thanks for the reponse, I appreciate it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top