time

[telcosub]

new system install ip 500 r11 basic setup using as key system but can not get the time and date changed on ext 10 I go to Admin- System Admin- System Parameters- system date try to change and reverts back to old date same with time tab, did not want to add essential license any ideas and what is the default working directory when you try to open a system with manager
Thanks
Telcosub

 

[telcosub]

could this be a bad R 11 sd card?

 

[telcosub]

thanks found problem bad sd card

 

[critchey]

Actually just fyi in basic mode it takes the time from callerID. This setting is under advanced is called network time synchronization and can be turned off and then you should be able to change on extension 10.

The truth is just an excuse for lack of imagination.

 

[telcosub]

Thanks