Hi
I setup NTP syncronization to our network time servers but I can't get it to recognize the daylight savings time settings in LD 2. When it syncs to the time server it sets the time 1 hour early which matches the time server time.
This is a CS1000E Cabinet with an SSC card and all TDM phones. No Sig Server so no Element manager. I set it up in LD 117. Release 5.0.
I have it disabled for now until I figure this out.
=> prt ntp
Primary IP Address: 10.249.0.1
Primary Key ID: 0
Secondary IP Address: 10.248.0.1
Secondary Key ID: 0
Minimum Threshold: 1
Warning Threshold: 6
Maximum Threshold: 16
Security Mode for Primary: INSECURE
Security Mode for Secondary: INSECURE
Time Interval and Offset: 24 30
Synchronization Status: INACTIVE
UTC Offset: -06:00
Mode of communication: CS
>ld 2
TFC000
.tdst
SDST ON
FWTM MAR 2 SUN 2 (AT 02:00 9/3/2008 )
BWTM NOV 1 SUN 2 (AT 02:00 2/11/2008 )
Anyone had any luck setting this up outside of Element Manager? I do have it working at another site but did it through Element Manager.
I setup NTP syncronization to our network time servers but I can't get it to recognize the daylight savings time settings in LD 2. When it syncs to the time server it sets the time 1 hour early which matches the time server time.
This is a CS1000E Cabinet with an SSC card and all TDM phones. No Sig Server so no Element manager. I set it up in LD 117. Release 5.0.
I have it disabled for now until I figure this out.
=> prt ntp
Primary IP Address: 10.249.0.1
Primary Key ID: 0
Secondary IP Address: 10.248.0.1
Secondary Key ID: 0
Minimum Threshold: 1
Warning Threshold: 6
Maximum Threshold: 16
Security Mode for Primary: INSECURE
Security Mode for Secondary: INSECURE
Time Interval and Offset: 24 30
Synchronization Status: INACTIVE
UTC Offset: -06:00
Mode of communication: CS
>ld 2
TFC000
.tdst
SDST ON
FWTM MAR 2 SUN 2 (AT 02:00 9/3/2008 )
BWTM NOV 1 SUN 2 (AT 02:00 2/11/2008 )
Anyone had any luck setting this up outside of Element Manager? I do have it working at another site but did it through Element Manager.