Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TFTP Load Aborted

Status
Not open for further replies.

fakename05

Technical User
Mar 20, 2006
63
US
I've got a system that has been randomly rebooting so I decided to load the software via DTE commands. I've done this many times before but this time I'm getting a message that says "TFTP Load Aborted (0x00000005)"

I have a bootp record with the proper MAC address and I also have it pointed to a IP500 bin file which should also be correct. I've disabled all of the other bootp entries.

It simply repeats the message:

ERROR: TFTP Load Aborted (0x00000005)
Erase Main Image Storage Area

Any ideas?
 
Did you try to turn off the firewall?
What are you using as tftp server?


BAZINGA!

I'm not insane, my mother had me tested!

 
The firewall is off and I'm using Manager as my TFTP server. I think I may try to use another ip500 but it doesn't seem to have the default IP addresses in it. I'm using Hyperterm and can watch it start to load. Can I use it to determine the IP address of the system? The EthPhyId is 0x0143BC30.

 
Connect with the serial cable and type this: (thanks to Intrigrant!)

at
OK
at-debug
<IPOffice Manager Version 0.2>
Wed 26/2/2014 10:27:58, Hello>updatelan

Current LAN1: ipaddr: 192.168.42.1 mask: 255.255.255.0 (LAN port)
Current LAN2: ipaddr: 128.75.0.100 mask: 255.255.255.0 (WAN port)
Enter which lan interface (lan1 or lan2): lan1 (or hit enter to leave unchanged)

Enter IP address (a.b.c.d): 10.10.10.1

Enter IP mask (a.b.c.d): 255.255.255.0

Add default gateway (yes or no)? 10.10.10.254
Start WriteConfig at f7e0969c, savemode SaveNormal, writetype ToFlash
Start WriteConfig at f7e0969c, savemode SaveNormal, writetype ToFile
:
:

Configuration has been saved.
Reboot now (yes or no)? no (enter to 'yes' to reboot system immediately)



BAZINGA!

I'm not insane, my mother had me tested!

 
Well, this doesn't appear to have any software loaded on it either so the above commands didn't do anything. I'm right back where I was -- a box that I can't seem to load the base software onto. I'm back at my original unit because it at least gives me the repeating error messages like it is attempting to do something.

This is not good. The system is down and they open in a few hours. ugh...
 
Install wireshark and only use the network interface connected to the IPO.
Boot it and see which IP address appears for the tftp request.

BAZINGA!

I'm not insane, my mother had me tested!

 
Thank you for all of your suggestions. The debug thing will definitely be helpful in the future.

I don't know why but I started it for about the 50th time and this time it started loading the software. I have no idea but I'm not going to complain. I'm putting it back together and heading home.

Thanks again!!
 
Next time hold the reset button between 10 and 30 seconds (orange flashing of the CPU led on the back)
This will erase everything except for the software on the system.


BAZINGA!

I'm not insane, my mother had me tested!

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top