Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Taking slips on a new Adtran 908E

Status
Not open for further replies.

jacabuk

Vendor
Jan 11, 2013
24
US
I just had a Cisco 3400E series router installed which is tied to a Adtran 908e. I am trying to interface two PRI's with dch's. The PRI's come up, but I am receiving non-stop receive errors (slipr) Has anybody experienced this scenario and have a solution. This is a cs1000m rls5
 
Pri These two are in the same cabinet?
If you are in the same cabinet separate them and you will not have errors slip
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top