T1 outgoing caller ID

[thephonelady]

Good morning all. I’m setting up an a T1 on an 11.0. Just temporary until the new PRI is working. The T1 was working on the old system (Merlin Magix) and was sending out the correct caller ID in the number to send option on the Magix. I can’t seem to get the outgoing caller ID to send from the ipoffice. The calls go out fine and come in as no caller ID. If I set the number in the ARS table using Nsxxxxxxxxxx I get unknown as the caller ID.
Any suggestions. The T1 is just being used for outgoing.
Thanks in advance.

 

[ThePhoneMn]

Try entering an "i" in the number string. Nsixxxxxxxxxx

Been there, done that

 

[rdoubrava]

There is no "standard" for outbound caller ID modification on a T1.
You are going to have to talk to your carrier.

How is your T1 setup ?

24 > 1
Network
D4
T1
AMI ZCS
CPE

Direction bothway E & M - Tie Wink-Start

 

[thephonelady]

Hi Phone Mn
Thank you.
I’ve tried is using Ns and Nsi and nothing.

 

[thephonelady]

I have it set as
24-1
Network
ESF
B8ZS
CPE
EM TIE
WINK START INCOMING AND OUTGOING
I will have the BP check with the provider.

 

[budbyrd]

I think I would get them to switch to a PRI if they can. So much easier to work with.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'