Swapping cards

[pse2002]

Hi,
I need to swap 2-port analog card with 8-port analog card. Also I need to move PRI daughter card from 2-port to 8-port card.
I would be very appreciated if you give me advice(s) how to swap the cards correctly. Steps and precautions.
I don't have any details, it is my upcoming job for one client.
2-port card has extensions created for this card as I assume. Will the new 8-port card reassign these two extensions for itself automatically or the system will create new extensions?
What about PRI channels that already exists.
Thank you.

 

[Westi]

no big deal really, the extensions you have right now will still be on the same two first ports on the 8 port card and the PRI will still have the same line ID. All you have is afterwards 6 additional analog ports. The extension ID's are selected by the system and it leaves room for bigger cards so that there is no shuffling around needed should you install a larger card but the additional ports are added on. Same is for expansion modules, if you replace a 16 port with a 30 port it has enough room to not push back any additional ports after that.
I hope I make sense as I am tired.

Joe W.

FHandw, ACSS (SME), ACIS (SME)


“This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter