sv9100 vrs in PRI LINE not support single digit or any digit vrs seding

[miteshrathod85]

i installed sv9100 with call center vizio software . i programmed vrs in call center vizio but problem in vrs .no support any digit in vrs

any idea ...for all nec engg.

 

[CoralTech]

Umm, gonna need a little more info. What are you trying to do? Some more detail please.

 

[miteshrathod85]

IN SV9100 ANY PROGRAMM FOR VRS SINGLE DIGIT RESIVE TIMERS

 

[AYAMJ]

Dear All Helpers

Sorry for bothering you

i'm a new @ NEC-Sopho
I've NEC-SV9100 connected to Sopho iS3000 using 2xPRI GCD-PTRA 4 wire Tied Line Trunk with 60 B-Channel
NEC-SV9100 has internal extensions of 4xxx and the Sopho has Analog Extensions [1xxx, 2xxx, 3xxx, and 5xxx] also has 34 PSTN Lines
when i dial from 4444 to 1602 the call established but when i tried to call from 1602 to 4444 i got busy tone coz there is no route configured for 4xxx on Sopho
how can i configure Sopho to know the IP Phone extensions on NEC-SV9100

i need OM command for this

also i need the IP Phones to dial 9 trunk access code on NEC then the NEC-SV9100 directly pickup any of the 34 PSTN lines on Sopho so i can establish external call from NEC IP Phones
i configure ARS and F-Route on NEC but when i dial 9 i hear another tone then i dial any mobile number i got on my NEC IP Phone Screen Line 001 then i hear silence only

i need OM command for this

Regards,
Ahmad

 

[CoralTech]

Look under 20-31-17. Without understanding what you are trying to do I'm just guessing. Most people confuse VRS with AA all the time.