Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SV8300 incoming SMDR on CCIS for remotre site.

Status
Not open for further replies.

soaressteevan

Technical User
Jun 9, 2008
96
AE
Hello Guys,

i have SV8300 systems working on CCIS over IP:

Site A is a main office with PRI line connected and Centralized Billing (ma4000) is working.
Site B is a remote site .

Site B is receiving a call from PRI, but i can not see the incoming calls on the smdr tool, or ma4000. but i can see it for outgoing calls made from here.

 
Try this;
To provide Tandem Centralized Billing in the Local Office
Data Assignment of Office A
CM08>040: 0 (Provides SMDR service for tandem calls)
CM08>377: 0 (Provides office number and station number from the tandem office)
CM35 Y=014>C.O. Route No.: 0 (Not provided)
Data Assignment of Office A
ARTD CDN 10>CCIS Route No.: 0
ARTD CDN 16>CCIS Route No.: 0
Data Assignment of Office B
CM08>378: 1 (Not provided)

Also make sure that incoming SMDR is set to all extensions. CMD 35049.

You can find this information in the Networking Manual.
 
Thanks Belvedere, i have done all these programs.
my PRI line is in the main site, calls are going via main site from remote site, there is a outgoing call details, even incoming call details are available on smdr tool, but it doesn't give extension number, it gives ccis route and trunk route. i need to have station number.
 
Do you get station number/name when you call station to station over CCIS?
 
Also set Command 1305 for all the SV8300 stations to "0
 
Yes Belevedere, i can see the station number.

1305 is 0 for all the stations in both the sites.

is this feature available on sv8300 on ccis?
 
It is a feature.
Check CMD's 35049>CCIS route>0 = allow incoming SMDR.
Also, some of the basic CCIS commands.
A80>destination point code>CCIS circuit, usually 00 if only one CCIS circuit.
A728>CCIS circuit>0 = calling party information transfer service.
EX: A728>00>0
A80>00001>00
35049>31>0
 
I have an SV8300 going to an SV8500-UMG. Below are my SMDR settings:
08-368-1
08-378-0
08-426-0
08-463-0
08-800-1 (Only used in 2000IPS)
3549-0
1305-0
15213-0 (Optional for SMDR for sta-to-sta calls)
A703-00-0
A704-00-XXXXX (XXXXX = Point Code of my SV8500-UMG which is the Center Billing Office)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top