Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spectralink 8030 and SVP server 8000 and Dlink AP

Status
Not open for further replies.

aboola

Technical User
Mar 10, 2009
26
AE
I have 3300 and Spectralink 8030 Wireless handset and SVP server , configure it as the manual say , but the phone give on screen no net Found and the AP mak address then 33
can any one help with that ?
 
Has the phone got the latest firmware?
Is it the same as your existing handsets?

Share what you know - Learn what you don't
 
What type of WLAN protocol are you using WMM, CCX or CCKM?
Is the handset set to the correct type?

Share what you know - Learn what you don't
 
it is set to SVP server and put SVP server IP address , and I am using authentication using WPA and try WPA2 too
 
As it is a SVP what model is it as some of them have a handset limit?

Share what you know - Learn what you don't
 
it is SVP 8000 and I have just tow phones
 
I think you have to setup a range of alias IP addresses along with real IP addresses.

Have you added all the config files to the TFTP server with the extn numbers

slnk-cfg.cfg
sip_allusers.cfg
sip_xxxxxx.cfg


Share what you know - Learn what you don't
 
what I must use for IP addresses range? range of phones IP's?
 
They need to be in the same subnet as the real ones so they can connect to each other

Share what you know - Learn what you don't
 
it is in same subnet , but I keep geting the same message and can\t ping the phone at all , it is like it is refuse the AP , my AP is no on certified device list , so it is will work or not?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top