Some noe can help me???-I could'nt log on to My billing

[anlly]

<CLOHI:FILE=CIL,FORM=4,DMPSIZ=1;
NOT ACCEPTED
FILE
NOT ASSIGNED
<CLOHI:FILE=CIL-1,FORM=4,DMPSIZ=1;
NOT ACCEPTED
FILE
NOT ASSIGNED
<CLODI:FILE=CIL-1;
NOT ACCEPTED
FILE
NOT ASSIGNED
<CLINP;
CALL LOGGING DATA
CALL LOGGING MODE: ACTIVATED
MOBILITY LOGGING MODE: NOT ACTIVATED
HEADER FORM DMPSIZ DISCR IN SERVICE LOGABN LOGFAL HRTBT
SMDR 2 4 0 YES NO 0 NO
ORIG DIAL TIME
ALL ALL ALL
DIR LIM BPOS EVENT

 

[himdp]

did you do CLDFI first?

 

[nithin6926]

Hi Buddy

you already have a file initiated "SMDR"

Do you require a new one here? If yes as HIMDP said you need to initiate the file with "CLDFI" otherwise the output file "SMDR" is well configured. check CLDFP;

Is it on serial connection or on IP?

--
Nithin

 

[anlly]

Its on serial connection.

====
CLDFP ;
FILE ADMINISTRATION DATA
FILE STATE
SMDR ACT
IODEV/PATH USER DEVICE STATE PRIORITY
/SYSN/USR1/ACS/CIL/ CIL-1 READY/STARTED C
END

 

[nithin6926]

Hi Buddy

As per this "/SYSN/USR1/ACS/CIL/ CIL-1 READY/STARTED C" you have an output file CIL-1 now whereas earlier it was only SMDR.

Did you initiate it?

anyways.. the " READY/STARTED " indicates that the output generation has started. you should get data on the serial port.

--
Nithin

 

[himdp]

Nithin,
the printout shows CIL-1 is the IODEV, the file name is SMDR and it is active.

 

[anlly]

CLDFP;
FILE ADMINISTRATION DATA
FILE STATE
SMDR ACT
IODEV/PATH USER DEVICE STATE PRIORITY
/SYSN/USR1/ACS/CIL/ CIL-1 READY/NOT STARTED C
END

<
TIME OUT WARNING

<
LOGGED OFF

 

[nithin6926]

Yes HIMDP, you are right. I might have overlooked it

@Anlly => Buddy, check it on Hyperterm, configuration is running good... still not coming,, try to change the I/O Port.

--
Nithin