sms via dect + command AT

[almasterweb]

Hello,

I have a DT570 connected to my pc via rs232 and i want to send sms message via command AT

I read de sms in my dect, i get this trame pdu but i can not decode it ?

AT+CMGR=1
+CMGR: 1, 34
D90103B941F502890000000001901032707085000E07C60102C502CAAB00B53CA703

If someone can help me thanks.

ps: sms dect to dect work good.

 

[doktor]

I think that this is only possble through the "ASCOM" web SMS service. So it should be done through a webserver connected to an ASCOM module (small white box), that send the signals on to the NIU board and the sms is transferred to the DECT handset (e.g DT400/410/420/430).

///doktor

 

[almasterweb]

Hi,
Thanks for your answer,

I think that can, because when i enter this command

AT+CMGS=15
000100039141F5000006D2E010992402

(this is a pdu trame.(work with a GSM)).

And the dect write the message is send but the message never arrived.

So my problem : i must decode this pdu trame:

AT+CMGR=1
+CMGR: 1, 34
D90103B941F502890000000001901032707085000E07C60102C502CAAB00B53CA703


Thank you for your help.

 

[etompau]

I wouldn't be suprised if this is some rest of programming code in the DT570 originating from the GH688 GMS phone, that cause the phone to respond on the AT commands.
I far as I remember Ericsson re-used part from the TH688 Dual mode (DECT/GSM) which then was built on tre GH688 platform, when creating the DT570.
Anyway good luck with your "project" .
Perhaps you could describe what you want to achive with your experiment, it might be that there are some other solutions to your neeeds.