SLMC Card is showing defect in OS4KV8

[eniyamath]

Hi friends
i am trying to configure SLMC card with CATool,but the cards are not become ready.

while configuring getting FILLEN errors and card come in active for 30 seconds and again shows DEFECT.

It is my first V8 installation and i have worked up to V7 configuring DECT.

Can any one guide me to resolve this issue.
Thanks

 

[eniyamath]

Dear Moriendi

it is a new installation and i am installing DECT in V8 first time

Please find below the attached loadware status of the card

 

[eniyamath]

Dear Moriendi

I am trying to paste the snspshot og the card manager but unable to paste so i attached the picture in attachement

 

[Moriendi]

I misunderstood. I saw the screenshots showed install on Enterprise Gateway. They were sbcsu's screenshots, not yours.

You are installing on LTU 1. So pzksgw50 is not relevant. My mistake. But, your SLMC loadware, 8/21, is good. That is the one to use.

I would make CAT generate a delete macro, remove everything cordless (DB admin, delete DB in Hicom). Then re-add. You shouldn't see SLCB errors like above. But CAT should do everything for you.

 

[eniyamath]

dear Moriendi

can you please help me to add one card by remote control if possible through any desk or team viwer, really not understand the issue

anydesk 113366646
teamviwer 1634060450


thanks

 

[Moriendi]

Can't do that right now, maybe later.

 

[eniyamath]

Dear moriendi

ok

 

[adibv]

If it is not too late

The performance optimization “QDCL” must be deactivated (CATool: Global Settings->QDCL=no)

There are some restrictions related DECT/CMI:

- CATool Info: New frame type not supported yet. Frame type AP370013 needs to be choosen. Further the Clock Source for that shelf must be set to “Central”
- QDCL is not supported. If QDCL is active the SLC boards will not startup. QDCL must be deactivated via CATool
- ISS and Front Reference is not yet supported (under QA)

Only AP 3700-13 supported.
AP3700-9 shelf will not be supported

Make sure you have the latest LW for SLMC boards.

And Change frame type in CATool to EntGW