SIP TRUNK - Mobile twining 1

[edvy123]

Hi,

I have a SIP trunk ( PRI) from service provider.
Call forwarding is working when i enter the DID number is User->sip TAB.
Whereas the mobile twnining doesnt work. The DID number rings on the extension , but while the external call is going its shows only teh extension number in the host side. 234@domain.com
if i dial from teh original extension then it show me proper DID number.
The service provider doesnt allow external caller ID to be published when calls are forwarded/twinned.
Have done changes in Originator number to be the pilot number.stil the calls are not going through

Kindly suggest

 

[icet500]

In the sip uri or call details, you have options to set send original caller id or whats in your uri.

It would be easier if you provide a screenshot of you sip line call details or uri!

 

[shamorau]

whats in the URI?

Also if you are using internal data have you populated the SIP tab for the user.

 

[edvy123]

hi,

have attached the screen shot..

Also in SIP tab for user - SIP Name -- DID number and contact its the DID number.

 

[icet500]

in sip line uri, change local uri, contact and display name to use internal data instead of auto.

 

[edvy123]

Hi,
Doesnt have any impact.
Forwarding works fine...
But when i do twinning the call initiates with extension number, how should i enable it to dial the whole DID number when the call is twinned?

 

[edvy123]

hi,
anybody can advice what changes to be done.

 

[telecomtekperson]

I dont know SIP very well...to get mine working, i used 2 URI's...got everything i needed for the inbound URI, then played with the OUtbound....from my experience, i couldnt get CID to be prper until had the 2 URI;s

 

[icet500]

What release is the IPO? And why do you have dots (.) in the originator number?

 

[edvy123]

Ip office is rls 10.1 . there are no dots in the originbating number..I have made it blank.
the process for forwarding gives me complete DID number to oudial, this same number i have defined in User SIP.
But when its twinned it just takes the extension number to dial out, and the call doesnt connect
2, SIP Message = Response, Call Ref = 90, Direction = To Switch, From = 806@4XXXX.XXXXXX, To = 0XXXXX@4XXXXX.XXXXXXX, Response = 200 OK

i have changed the domain for security purpose.
For a normal forwarded call the "From " number is correct DID number and the call goes through..

 

[edvy123]

guys - it worked..
I did select Internal data,and had to do some modifications in incoming group and keep the same in user SIP Tab
Thanks