3300 CX II / MCD 7.1
E1/T1 card
PRI-ISDN with SingTel
Hi all,
Can anyone assist with configuration settings.
I am not on site, or in country and trying to configure remotely.
E1/T1 card is patched through to NTU ready to go.
SingTel advise service is active / tested.
I have been told that SingTel use Euro ISDN / ETSI protocol, which I have configured up and I can only get a blinking green light on E1/T1 card at best (Close but no cigar). System Logs show sync and D channel down. I have tried Toggling CRC on and off in the digital link descriptor to no avail.
E1/T1 card
PRI-ISDN with SingTel
Hi all,
Can anyone assist with configuration settings.
I am not on site, or in country and trying to configure remotely.
E1/T1 card is patched through to NTU ready to go.
SingTel advise service is active / tested.
I have been told that SingTel use Euro ISDN / ETSI protocol, which I have configured up and I can only get a blinking green light on E1/T1 card at best (Close but no cigar). System Logs show sync and D channel down. I have tried Toggling CRC on and off in the digital link descriptor to no avail.