Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Shutdown, Restart & Battery change BCM 3.7

Status
Not open for further replies.

desertinn

Vendor
Nov 28, 2010
324
US
I have a customer with a BCM 400 SW 3.7 with a Smart UPS 1400xl.

This has been installed for over 10 years now and is pretty good condition. I believe the batteries need to be replaced on the UPS.

I also need to graceful shutdown the BCM and restart it because all 8 Analog ports are only provding battery and no dial tone and I want to see if a shutdown and restart will resolve this issue or if the Analog Service Module is bad.

What is the best procedure for shutting down the BCM and changing the batteries?

I found this thread regarding the UPS and BCM so I am wondering if I should just let the batteries run down and let the UPS do the Graceful Shutdown.


gberger (TechnicalUser) 11 Aug 09 22:39
From the Bcm4.0 Installation and Maintenance Guide;Uninterruptable power supplyAn uninterruptable power supply (UPS) is an optional device that maintains continuous operationduring power interruption or failure conditions. The UPS provides power source monitoring andbattery backup activation so that critical BCM functionality is maintained.In a power failure situation, the UPS provides sufficient time to either correct the problem oractivate a contingency plan to sustain services. The UPS is configured to perform a gracefulshutdown of the BCM 2 minutes before the UPS battery power is drained.The BCM system supports American Power Conversion (APC) UPS devices that use a USBcontrol interface. These include the APC UPS-Smart family (for example, UPS-Smart 750,UPS-Smart 1000) and UPS-Back family (for example, UPS-Back 500 ES, UPS-Back 350 ES).The UPS control software enables the configuration of various operational settings.On BCM systems with more than one unit, the power supplies for all of the units must beconnected to a single UPS.The UPS feature is supported in all markets (110~120V and 220~240V power standards).Supported on previous Bcm versions as well.
 
That is most likley if it is connectet to the BCM usb I/F but in the config section click on the system and go to the log off it should give you rebbot or shutdown.
 
yes it is connected to the bcm because I will be able to pull ups information on the performance of the u s p device itself
 
Yes, I have been having it auto back up everyday now for the last month.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top