Setting up SCN first time

[itguy399]

Hi
I have 2 IP Office 500 v2 r7 system set up at different locations, sites connected via IPsec VPN tunnel.

Any help is greatly appreciated

Site A:

License
IP500 Voice Networking Channels

Ip Route settings
Ip Address 0.0.0.0
Mask 0.0.0.0
Gateway 10.1.2.1
Destination LAN1

Line Settins
Line H323
Line #17
Incoming ID 0
Outgoing ID 0

VoIP Setting
Gateway Ip Address 10.1.1.222 (Site B IP Office LAN addess)
Compression Mode (Auto Selection)
Supplemental Services (SCN)

Site B:

Licenses
IP500 Upgrade Standard to Professional
IP500 Voice Networking Channels
IP500 Voice Networking Channels
Mobility Features
Phone Manager Pro (per seat)
Phone Manager Pro IP Audio Enabled (users)
Preferred Edition (VoiceMail Pro)
VCM Channel Migration

Ip Route settings
Ip Address 0.0.0.0
Mask 0.0.0.0
Gateway 10.1.1.200
Destination LAN1

Line Settings
Line H323
Line #17
Incoming ID 3
Outgoing ID 3

VoIP Setting
Gateway Ip Address 10.1.2.222 (Site A IP Office LAN addess)
Compression Mode (Auto Selection)
Supplemental Services (SCN)

 

[itguy399]

ok

Status is Green
Remote table green
Generated BLF green

All the values in the table are 0

 

[Gunnaro]

OK, these are all good things, but did you do anything right now?

Kind regards

Gunnar
__________________________________________________________________
Hippos have bad eyesight, but considering their weight, it’s hardly their problem

 

[itguy399]

No I am going to renumber trunks at site A because they conflict with Site B extensions and reboot system after they close for the day. Tomorrow I will look into firewall and configure short codes to see what happens. Thanks for the help

 

[Gunnaro]

Yes, as previously mentioned, clean out all conflicts and then you should be fine.

Enable [SCN Discovery] in Manager: File>Preferences>Discovery, and put this in [search criteria]: 10.1.2.222; 10.1.1.222;
Enables you to open both Systems simultaneously.


Kind regards

Gunnar
__________________________________________________________________
Hippos have bad eyesight, but considering their weight, it’s hardly their problem

 

[itguy399]

Gunnar

Thanks for all your help, just finished another project so back on this issue. I can now open both configurations within the same session. Still unable to make calls between locations. When I look at the IP trunks I created, it states SCN is DOWN.

Do I need to create any additional routes on the firewall?

 

[Gunnaro]

Good morning!

I normally start without the firewalls on, just to make sure my programming is correct.

If you want, I can take a look at the configs for you. See my QR code in the signature for where to send both .cfg files.

Kind regards

Gunnar
__________________________________________________________________
Hippos have bad eyesight, but considering their weight, it’s hardly their problem

 

[itguy399]

Gunnar

When I scan your code it does not show a valid email address, I used several different code readers.

 

[Gunnaro]

Mine workd, but ok:
go (at) smartkon (dot) no

Kind regards

Gunnar
__________________________________________________________________
Hippos have bad eyesight, but considering their weight, it’s hardly their problem

 

[itguy399]

ok sent