Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Res 3700 error - Unknown unsupervised abort code
- Thread starter POSN
- Start date
This is usually from a windows update on the workstation. Its typically one you cant uninstall either.
You can do a factory reset of the workstation(must be the bios reset)
Or can try this;
For workstation 620 & 650 you must copy ntidn.sys from 5.5 installation disk (System32\Drivers) to C:\Windows\SysWOW64\drivers and reboot workstation.
After reboot you will have no problem.
Once you reset make sure the workstation is set to check for updates but not download or install.
Look for port driver updates and exclude/hide them.
You can do a factory reset of the workstation(must be the bios reset)
Or can try this;
For workstation 620 & 650 you must copy ntidn.sys from 5.5 installation disk (System32\Drivers) to C:\Windows\SysWOW64\drivers and reboot workstation.
After reboot you will have no problem.
Once you reset make sure the workstation is set to check for updates but not download or install.
Look for port driver updates and exclude/hide them.
Two possible causes
you must copy ntidn.sys from the 5.5 installation disk (System32\Drivers)
Windows update Exar Corporation - Ports driver update. This update removal hard lot of entry. Better format and windows update to disable.
Re cal
you must copy ntidn.sys from the 5.5 installation disk (System32\Drivers)
Windows update Exar Corporation - Ports driver update. This update removal hard lot of entry. Better format and windows update to disable.
Re cal
- Status